nikola
A rock breaker is a machine that is designed to manipulate and break large pieces of rock into small pieces. They are also called hydraulic hammers and they are mainly used in the mining industry. They are used to breakdown large pieces of rock or that are too large. They are eventually crushed and reduced in size by the use of a crusher. Mainly there are two main types of rock breakers, one being mobile and the second being stationary. If you don’t know much about rock breaker then there is nothing to worry about as this article has got you covered. This article will guide you through the 5 tips to get the most out of your rock breaker.
Visit Duraflex Australia for more info.
Visual inspection and Visit Duraflex Australia for more info
One of the key factors to get the best out of rock breaker is to go through its inspection visually. It hardly takes several minutes to inspect the respective rock breaker and to look for any wear and tear. It is suggested that visual inspections shall be performed after every use of a rock breaker. This will help you highlight and see the damaged or worn components which will help you eventually and would prevent and minimize any unseen downtime. One should go through different areas such as attachments pins, hydraulic hoses, tool retainers, and breaker shells too.
Greasing the machinery
It is suggested that whenever one uses any machinery, they should properly grease it. It is of great advantage as it is seen that clearing the brushing area and greasing it can extend the lifespan of the machinery. It is advised to grease it at regular time intervals. Visit Duraflex Australia for more info. Most importantly it is suggested that whenever one applies greasing to the area or machine, one should not do it without any knowledge or instruction but should always read the instructions from the manufacturer’s recommendations.
Inspecting nitrogen pressure
When discussing the rock breaker, talking about the nitrogen pressure is way too important. The reason behind this is that the nitrogen gas helps the system which works along with the rock breaker. To make sure it works and performs correctly and smoothly one shall inspect and check the nitrogen pressure and shall make sure that it is up to the mark. Visit Duraflex Australia for more info. Mainly it is said that the nitrogen pressure depends on the application is self and the working temperature where the rock breaker is being operated.
Perform regular check and Visit Duraflex Australia for more info
As discussed earlier, it is important to keep a check on the machinery and perform regular checks to make sure that everything is in the working. One should inspect and make sure chisel, bushes, and chisel pin are in the correct order. Excessive and overuse wear of the bushes and chisel can also lead to chisel head and piston being damaged.
Servicing rock breaker
Like any regular machinery, rock breaker is also in need of servicing from time to time. And it shall be made on a regular basis. This makes sure that the device and machinery work correctly and would help in its long run. Moreover, it also increases the durability and life expectancy of the machinery. Visit Duraflex Australia for more info.
